howtos:sdr
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
howtos:sdr [2021/06/07 18:43] admin |
howtos:sdr [2021/06/07 21:44] (current) admin |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| * [[https://github.com/EliasOenal/multimon-ng|multimon-ng]] | * [[https://github.com/EliasOenal/multimon-ng|multimon-ng]] | ||
| * [[https://github.com/merbanan/rtl_433|RTL 433]] | * [[https://github.com/merbanan/rtl_433|RTL 433]] | ||
| + | * [[https://www.ebay.co.uk/itm/203134008519|RTL SDR device on ebay]] - This is the model I use, but pretty much any RTL2832 chip device should work out of the box with Linux (performance may vary based on the the quality of the device). | ||
| ===== Command Line ===== | ===== Command Line ===== | ||
| Line 19: | Line 20: | ||
| </code> | </code> | ||
| - | To generate the heatmaps of what's happening in your area, use the ''rtl_power'' (in the rtl-sdr debian package) with [[https://github.com/keenerd/rtl-sdr-misc/blob/master/heatmap/heatmap.py|heatmap.py]]. For more information see http://kmkeen.com/rtl-power/ | + | To generate the heatmaps of what's happening in the radio spectrum in your area, use the ''rtl_power'' (in the rtl-sdr debian package) with [[https://github.com/keenerd/rtl-sdr-misc/blob/master/heatmap/heatmap.py|heatmap.py]]. For more information see http://kmkeen.com/rtl-power/ |
| Run this for 24 hours (you can also just try an hour or so and repeat to test different aerials): | Run this for 24 hours (you can also just try an hour or so and repeat to test different aerials): | ||
howtos/sdr.1623087785.txt.gz ยท Last modified: 2021/06/07 18:43 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
